Skopje Wireless Network Forum

Има вакви неколку случаеви предходно на форумот што веќе сме одговориле

Секогаш пред да флешуваш нешто почитувај го и знај го ОВА. Е сега како што знам треба преку tftp опцијата за upgrade да направиш. Еве ти hints за полесно да се снајдеш. Ова до сега го немам правено но според тоа што прочитав не е нешто сложено, има се објаснето.
1)OpenWRT TFTP Way Flashing
2)DD-WRT Recover from a Bad Flash
3)The WRT54G Revival Guide
А во најкратки црти еве што треба да направиш:
meakerb wrote:

I followed the steps outlined by Tom for setting the speed and fixed IP address.

Instead of using the TFTP program aquired from http://www.dslreports.com/forum/remark, … Bmode=flat I found that Windows XP has a TFTP program itself.

I downloaded the latest firmware file from the Linksys website and renamed it to code.bin.

Note that there is a size limit to the file that TFTP will transfer, so don't try to directly load Alchemy 6.0 RC5A

I connected directly to the router (LAN port) from the PC without any other connections from the router to cable modem (WAN port).

In a command window (what I used to call a DOS window) move to the directory containing the code.bin file.

Type the command: TFTP -i 192.168.1.1 PUT code.bin (don't hit Enter yet)

Unplug the router, wait a minute, then plug it in.

Within a couple of seconds of plugging the router in, hit Enter on the PC to start the TFTP program.

Wait for the TFTP program to complete, then wait an additional minute or two for the router to reboot.



In my case, the TFTP program reported successfully transfering the firmware.
Normally I would have been done. However, I tried pinging the router again and it didn't respond properly (I don't recall exactly what the response was). But I tried connecting from the PC to the WAN port and I was able to ping the router!


Be aware that sometimes loading new firmware causes the LAN and WAN ports to swap!?!

I connected to the router via the web interface and then did a firmware update to Alchemy 6.0 rc5a. When the web page indicated success, I moved the connection back to a LAN port (and waited a couple of minutes for the reboot).

Now my router is alive and has the new firmware

Thanks to TheIndividual and Tom for their posts, Also a thanks to everyone else who posts/responds in these forums, their experiences provide help for those that struggle like me. Hopefully someone else will benifit from what I've learned.

Со Среќа, па пиши што си направил

Веќе неколку пати пишав ама еве да споделам updated линкови за recovery from bad flashing:
1)DD-WRT
2)how to flash the wrt54gl with dd-wrt firmware

НОД32 није много сигурна користим га много пута и тестирати га да не открије нови вируси

Last edited by steven444 (10-05-2010 21:39:02)